All EP Programmers
The Fireye EP Programmer Modules are used with the Flame-Monitor Burner Management Control System (P/N’s E110 and E100). They provide start-up programming, safe start check, and flame monitoring supervision. They insure open damper high fire purge interlock (EP100 series only), proof of low fire position and fuel valve end switch safety checks. A running interlock circuit on the Flame-Monitor system constantly monitors the limit switches, air flow switches, and fuel pressure switches through the programmer. The EP programmer modules will de-energize all fuel valve circuits with 4 seconds (max.) following a flame failure (2 seconds for the EP165, EP166, EP265), or at the end of the pilot-trial-for-ignition period if no flame is detected. A modulator (firing rate motor) circuit is provided on the EP100 andEP200 series programmers. The EP300 series programmers do not provide a modulator circuit. The EP programmers provide a Check-Run switch to stop the control in its firing sequence at any time (except MTFI) to aid in set-up, start-up, and check out of the burner and its associated interlocks.
The EP programmers offer the following selectable functions: increase purge timing, require the air flow switch (terminals 3-P) to be open at the start of the operating cycle, recycle or non-recycle operation (EP300 series only), and intermittent or interrupted operation of terminal 6 (EP300 series only). The EP programmers include an RJ45 style connector to interface with the ED510 display module (mounted local or remote) and two (2) RJ style connectors to connect to an E500 communication interface wired in a multi-drop configuration. The EP programmers store the burner cycle and on-time history, as well as lockout history (with burner cycle and burner hour time stamp).
Programmer. Selectable purge, selectable TFI, non‐recycle, EP100F French language.
Programmer. Selectable purge, selectable TFI, non‐recycle, Spanish language. EP100S
Programmer. Selectable purge (30 sec min.), 10 and 15 sec. TFI, non‐recycle. EP160
Programmer. Selectable purge (30 sec min.), 10 and 30 sec. TFI, non‐recycle. EP161
Programmer. Selectable purge (30 sec min.), selectable TFI via ED510 display, non‐recycle.
Programmer. Selectable purge (30 sec min.), pilot stabilization, non‐recycle, 10 and 10 sec TFI.
Programmer. Selectable purge (30 sec min.), pilot stabilization, non‐recycle, 10 and 15 sec TFI programmer. EP166
Programmer. Selectable purge (30 sec min.), 5 and 10 sec. TFI, non‐recycle, early spark termination.
Programmer. Selectable purge (30 sec min.), 5 and 10 sec. TFI, non‐recycle, early spark termination. M‐D circuit must be proven through the completion of MTFI. EP174
Programmer. Early spark termination. ED510 to select purge (30 sec min.), prove air flow, prove high fire, prove low fire, and post purge. Early spark termination. Infinite hold on M‐D circuit. EP177
Programmer. Selectable purge (30 sec min.), selectable TFI, recycle, French language.
Programmer. Selectable purge (30 sec min.), selectable TFI, recycle, Spanish language. EP200F