All FLAME MONITOR
The Fireye® FLAME-MONITOR™ System is a microprocessor based burner management control system designed to provide the proper burner sequencing, ignition and flame monitoring pro-tection on automatically ignited oil, gas, and combination fuel burners.
FLAME MONITOR Subcategories
The Fireye E300 Expansion Module provides increased interlock supervision capability of the Flame-Monitor® System. The Expansion Module connects to any EB700 Flame-Monitor Chassis by means of a ribbon cable. (P/N E350-3, E350-6). By wiring an […]
The Fireye EP Programmer Modules are used with the Flame-Monitor Burner Management Control System (P/N’s E110 and E100). They provide start-up programming, safe start check, and flame monitoring supervision. They insure open damper high fire p […]
The FIREYE E1R1, EUV1, ERT1 and EUVS4 Amplifier Modules are used in conjunction with the FIREYE FLAME-MONITOR system. These modules provide flame scanning using any of the FIREYE AutoCheck infrared scanners, standard ultraviolet scanners, flam […]
Remote Display Housing Blank Display Module Multi-Port Cable Connector and Terminal Strip Remote Reset Cables Remote Display Cables
The Fireye Flame-Monitor programmers, type EP178 and EP378, with the EDC1 or EDC2 amplifiers, are specially designed to operate as a primary burner control use specific models of the InSight and Phoenix integrated scanners as the flame detecto […]
FLAME MONITOR Components
Infrared autocheck amplifier, use with 48PT2. Special application only, consult ITS. E1R2
Ultraviolet self check amplifier. Use with 45UV5‐1005, ‐1007, ‐1008, ‐1009, or 55UV5‐1007, ‐1009. EUVS4
Programmer. Keypad adjustable purge time, PTFI time, MTFI time, post purge time, early spark termination, pilot proving period, and indefinite hold on low fire start. For use with EDC1 and EDC2 amplifiers. EP178
Programmer. Keypad adjustable purge time, PTFI time, MTFI time, post purge time, early spark termination, pilot proving period, and indefinite hold on low fire start. No modulation. For use with EDC1 and EDC2 amplifiers. EP378
Amplifier, for use with EP178 / EP378 and one or two 85UVF4‐ 1QDWR, 85IRF4‐1QDWR, or InSight flame scanners (with 59‐497 ‐020WR cable). EDC1
Amplifier, for use with EP178 / EP378 and two 85UVF4‐ 1QDWR, 85IRF4‐1QDWR, or InSight flame scanners (with 59‐497‐020WR cable) to monitor pilot and main. Scannersautomatically switched at appropriate time. EDC2
